THE WORLD OF FREE PACKET RADIO SOFTWARE IN AMSTERDAM
SYMEK TNC 3S DUAL PORT HIGH SPEED PACKET CONTROLLER
THE SYMEK TNC3S DUAL PORT HIGH SPEED PACKET RADIO CONTROLLER
THE DESCIPTION OF THE SYMEK HIGH SPEED TNC3S
Based on the proven TNC3S with High Speed Processor MC68302, the TNC31 was developed as smaller and low cost version.
The main difference is, that the TNC31 has only ONE modem slot and less memory.
The software of TNC3 and TNC31 is identical !
There is one slot for a modem in TNC31.
You can choose one of the SYMEK modems 1200 Baud AFSK, 9600 Baud FSK or other speed FSK modems and install it into TNC31.
The modem can be changed or upgraded whenever necessary.
Software see description of TNC3: Turbo Firmware by DL1GJI with 10 up to max. 50 logical channels, mailbox for up to 10 user logged-in simultaneously, KISS, SMACK, Hayes SLIP, test program, DAMA.
Compatible to most common packet radio terminal software as GP, SP, AHP, TOP, VP, PAXON, STOP, Winpack etc.
Download of TNC3 Programs from diskette to CMOS RAM or Flash EPROM possible.
With X-Net Software the TNC31 may be used as The Net Node, Flex Net and TCP/IP node.
TNC31 is plug-compatible to most TNC as TNC2S, TNC2H and TNC3. The TNC31S can be used with every computer with RS232 interface.
The supplied disc offers some programs for PC DOS, Windows, LINUX.
A RS-232 serial cable with 9-pin sub-d connector female and a power supply cable is included.
Options: TNC31S 128 Kb RAM, 128 Kbytes Flash or TNC31SX 512 Kbytes RAM, 512 Kb Flash, Real Time Clock.
THE POWER SUPPLY
12 V DC 8 to 25 Volt, 60 to approx. 350 mA depending on modems, supply voltage and software.
THE DIMENSIONS
Ca. B = 104, T = 130, H = 42mm, mass 400 Grams
THE MODEM INTERFACE
20-pin connector for flat ribbon cable: GND, 5 Volt max. 400 mA for both modems, TXD, RXD, TX Clock, RX Clock, DCD, PTT, CTS, Reset.
Baud Rate 0 up to 1,2 MBaud, TTL levels CMOS.
Protocol: AX.25 HDLC Amateur Packet Radio Standard.
THE LED DISPLAY
PWR, CON Connect, STA Status, HALT, ERROR
THE CPU
Motorola MC68302 with 14.7 MHz clock, 8 bit external bus to RAM and ROM, battery buffered CMOS-RAM and TNC31SX only real time clock chip.
THE RS-232 PORT
75 baud up to 115200 baud, no hardware-handshake, Software selectable.
THE TNC31S INCLUDES
The TNC31S and TNC31SX base model consists of the motherboard with 128 Kbytes 512 Kbytes CMOS RAM and 128 Kbytes, 512 Kbytes Flash-EPROM but with NO modems.
As modem, you can select one out of a variety of AFSK and FSK modems, which will is built in according to your order.
If you order different modems later, it is easy to change the modem later by the customer.
For operation of TNC31 you need a additional cable between the modem 5 pins din connector and your radio.
Power supply and RS-232 cable 9 pin sub-d female at the computer side are included.
Modems and optional memory etc. is ready built in.
The TNC31 is supplied with English language manuals for customers outside of Germany, Austria and Switzerland and with a 3 1/2 inch software disk.
THIS IS A WARNING FOR COPYRIGHT PROTECTED MATERIAL
All Rights Reserved.
No part of this website or any of its contents may be reproduced, copied, modified or adapted, without the prior written consent of the author, unless otherwise indicated for stand-alone materials.
You may share this website by any of the following means: Using any of the share icons at the bottom of each page Google Mail, Blogger, Twitter, Facebook, GoogleBuzz.
Providing a back-link or the URL of the content you wish to disseminate; and you may quote extracts from the website with attribution to www.alwaysfree.nl.
For any other mode of sharing, please contact the author at the email.
Commercial use and distribution of the contents of the website is not allowed without express and prior written consent of the author.
THE WORLD OF FREE PACKET RADIO SOFTWARE IN AMSTERDAM