THE NL3ASD MODIFICATION FILES - THE HAM RADIO MODIFICATION - PAGES PAGES E TO H | HOMEPAGE |
could not open /dev/kbd to get keyboard type US keyboard assumed could not get keyboard type US keyboard assumed could not open /dev/kbd to get keyboard type US keyboard assumed could not get keyboard type US keyboard assumed Subject: YAESU FT767GX mod Message-ID: <8908221542.AA00047 From: Kendell_Chilton Date: 22 Aug 89 14:42:58 GMT I have recently purchased the aforementioned transceiver. I have had no problems to speak of and enjoy the rig thoroughly. I would like to submit the following mod for the rig. Note that implementation on this mod is at the rig owner's risk and may violate warranties. Here is a description of the mod: o Remove the bottom cover (8 screws:4 underneath, 2 on each side) o Remove the plastic rear panel. (Just a cosmetic piece) o Remove the rear metal panel. (So many screws) o Loosen the "hinge" screws on the front bottom. There are 4 of them. o Lift the now loose card tray to expose to inner circuit boards. Be careful! There are two power supply lines that need to be disconnected. (Remember to reconnect them on assembly.) (one is the control board, the other the one we want.) Note that the board we will mod is the same one that has the switch that allows changing the tuning dial from 5kHz/rev to 10kHz/rev. o Change the position of switch S01. The rig will now transmit from 1.5 to 29.99999 MHz. o Reverse the disassembly procedure. Well that's it. You are now ready for any band addition that may come our way. If you have problems, reply; I'll try to answer your questions. 73s de KA1TIH : Kendell_Chilton From mbrinkho From: "Matt C. Brinkhoff"SOURCE: The QRZ Windows Ham Radio CDROM
Source QRZ: The Windows Ham Radio CDROM
The World of Free Packet Radio Software Amsterdam The Netherlands - All Rights Reserved |