|
|
 |
| HOMEPAGE | THE WORLD OF FREE PACKET RADIO SOFTWARE AMSTERDAM THE NETHERLANDS |
|
From: John Dewey Subject: The Alinco DX-77T Modificication. There is a jumper inside the Alinco DX-77T to provide +8v bias on the microphone audio + line. If you enable this Jumper you can use Electret microphones with out having to build a separate voltage insertion circuit. JP1 is just to the rear of VR14 the Microphone Gain control on the PC board You can find JP1 on the schematic which came with the radio Just above VR14, and just left of TP1 The bias circuit consists of R338, R339 and C281 all of which are already present on the board Actual bias voltage will be less than 8v depending on the load presented by your microphone. I used a magnifying glass, and a sharp grounded soldering iron to bridge the solder pads JP1 Be sure to open up the original hand MIC and install a capacitor in the audio line to avoid having DC running through the coil of the dynamic microphone. I have also seen a mod to change the radio's band plan. One jumper sets US Bands, One sets Japanese bands. Both set EPROM bands and NONE sets the radio unrestricted I saw this information in a copyrighted book, and once on a news group. I have no need to go out of band, so I did not note the details I suspect this would upset the radio's band scan feature, which causes it to scan with in a specified amateur band. 73's John Dewey the KA9CAR |
|
By using this website you agree with this disclaimer. You can visit this website without telling us who you are or providing any information. About yourself however, there are situations where we may need information from you, for example, to correspond, to post or to achieve a registration. Reservation with you We aim to let you know before we collect personal information via the internet at any time. This website uses a counter to the number of visitors to the sites where they come from and what provider has access to the Internet. One The results are only in not individual identifiable form and in aggregate. Collected personal information will not be sold to third parties or made available. Exception of special circumstances, such as required by law. You can also ask at any time to be removed. Your information from our files all information on this website is intended for personal use. No rights can be derived from this information. We strive to make possible to be. The information on this website as complete and accurate www.alwaysfree.nl accepts no responsibility for damage of any kind whatsoever arising from use, incompleteness or inaccuracy of the information provided on this website. The information and recommendations on this website are subject to change., Without prior warning or notice. We strive to make this website available as much as possible but we accept no responsibility for any consequences of temporary unavailability. The copyright in this website rests with www.alwaysfree.nl or third parties who have made this material to www.alwaysfree.nl available with permission. Duplication in any form is allowed only after prior approval by www.alwaysfree.nl or third parties who have made this material available. |
