Date: 25 JAN 1999
Subject: Expanded TX modification for the Alinco DR-140-T:
============================================================== PROCEDURE:1 Remove radio from power supply.
2 Open the case top by removing the four screws 3 Locate the blue loop of wire behind the display on left,
near the tone decoder board, (with radio display facing toward you) 4 Cut the blue loop of wire, and tape
off loose ends 5 Replace cover to the radio 6 Reset the radio by holding the function key down and
turning on the power Note:Resetting radio will also require re-programing all user set memories TX
frequency coverage is now increased to 136.000 - 173.995 MHz
============================================================== WARNING & DISCLAIMER:This author does not
guarantee or warranty either specific or implied, any radio modification listed in this writing Any
modification which causes operation outside of the ham bands with any Alinco product will result in voiding
any warranties associated with their transceivers Transmitting on non-amateur frequencies with a FCC
type-accepted amateur transceiver and/or frequencies not licensed to the operator is illegal This
modification text is for reference only ! ==============================================================
<'}}}>
<"73" from the cornfields of Indiana WW - KB9TMP <'}}}>
Source QRZ: The Windows Ham Radio CDROM |
